NOTE
Except for the Overlap, the setting of the geometry
values for ISOBUS implements is performed only
through the Universal Terminal.
5.5.1 Overlap, setting
Overlap can be used to influence the track line spacing
for track guidance. When the vehicle is following the
track lines, the implement protrudes into the already
worked area by the defined value.
NOTE
This setting does not affect the overlap of the
automatic part-width section control.
1. In the setup menu, tap on
"Implement"
>
"Geometry"
.
2. Select geometry value
"B"
.
3. Enter the value.
4. Confirm with
.
5.6 Configuring the part-width section control
5.6.1 Configuring part-width section control for field sprayers
Configuring the part-width sections
In this menu, the part-width sections can be configured.
004995
005564
005438
005439
F | Configuring the AMAPAD | Configuring an implement
MG5574-
EN
-II | B.1 | 25.10.2016
90
