NOTE
For ISOBUS implements, the configuration of the part-
width sections is performed only through the Universal
Terminal.
For information on the configuration of part-width
sections for non-ISOBUS implements, see
page 227.
Tact
In this menu, the on/off point delays for switching the
individual part-width sections are set. The part-width
sections can also all be set together to the same on/off
point delay on the
"All"
line.
NOTE
For ISOBUS implements, the configuration of the
on/off point delays is performed only through the
Universal Terminal.
For information on the configuration of on/off point
delays for non-ISOBUS implements, see page 227.
Configuring the virtual section switch
The virtual section switches can be included on the
function bar in the operating menu and in the job view.
1. In the setup menu, tap on
"Implement"
>
"Section
control"
>
"Section switch"
.
2. Tap on
"Type"
.
3. Choose
"Virtual"
in the selection list.
4. Confirm with
.
5. Tap on
"Switches"
.
6. Enter the desired number.
005425
005416
F | Configuring the AMAPAD | Configuring an implement
MG5574-
EN
-II | B.1 | 25.10.2016
91
