The
"Exclusion areas"
button turns green.
7. With the
"Minimum exclusion area"
setting, the
minimum size for exclusion areas is defined.
8. Confirm the settings with
.
The boundary lines will be created according to the
settings.
9. Check on the map whether the boundary lines have
been properly created.
10.
If the boundary lines were not properly created,
cancel the procedure with
and adjust the
settings.
or
If the boundary lines were properly created,
accept the boundary lines with
.
11.
To edit boundary lines,
3
Editing the boundary line
1. Place your finger on any point on the map.
1
2
006958
J | Managing fields | Editing the boundary line
MG5574-
EN
-II | B.1 | 25.10.2016
135
