The
"Steering status"
will be opened.
Steering status overview
To be able to start automatic steering, certain conditions
must be fulfilled. The steering status provides
information on these conditions. The following table
contains measures to fulfil the conditions.
Red status display for:
Measure
Receiver hardware
Check whether the GPS receiver is properly connected, fastened and switched
on.
Differential correction
Check whether the correction source was properly configured, see page 55.
Position accuracy
Check the GPS data, see page 105:
The correction source must converge
Satellite data must have high precision
At least 4 satellites must be available
The correction source must match with the settings If the correction source is
wrong: select the correct correction source, see page 55.
If trees, high-voltage lines or similar interfere with the reception, drive the vehicle
into an open area.
002514
M | Using automatic steering| Calling up the steering status
MG5574-
EN
-II | B.1 | 25.10.2016
169
