1. Under
"Overlap tolerance at boundary line"
, enter
the desired overlap tolerance with the slider bar.
2. Confirm the settings with
.
2.2 Defining the boundary limit
The boundary limit is used to define the areas in which
the part-width section are automatically switched off. The
possible settings are listed in the following table. The
figures show the display in the map view on the
AMAPAD. The part-width sections remain switched on in
the light grey areas, and are switched off in the dark grey
areas.
009824
P | Using part-width section control| Using automatic part-width section control
MG5574-
EN
-II | B.1 | 25.10.2016
191
