1. Select
"Setup menu"
>
"User"
>
"User controls"
.
2.
To enable or disable the menus for the individual
user access levels,
select the
or
buttons in the corresponding column.
3.
To see a preview of the configured user interface,
select
"Preview"
in the corresponding column.
The button is then labelled with
" Exit preview "
.
4.
To exit the preview of the configured user interface,
select
"Exit preview"
.
5.
To reset all of the settings,
select
"Reset"
.
NOTE
The settings can be reset as follows:
To the factory settings
To the version before the AMAPAD was switched
on last
3
Entering the system settings
3.1 Configuring the functions
REQUIREMENTS
User access level has been set to
"Standard"
or
"Expert"
3.1.1 Configuring the functions of the console
Enabling the cameras
With the camera function, images from a connected
digital camera can be transmitted to the AMAPAD.
005556
005367
005366
005365
F | Configuring the AMAPAD | Entering the system settings
MG5574-
EN
-II | B.1 | 25.10.2016
42
