IMPORTANT
Damage to the depth control wheel due to
abrasion by the scraper
To check the distance,
rotate the depth control wheel
2.
If the distance is larger or smaller than 3 mm,
Loosen the nuts
3
.
3.
Adjust the depth control wheel scraper
1
.
4.
Tighten the nut.
5.
To check the distance,
Rotate the depth control wheel again.
6.
If the depth control wheel scraper cannot be
readjusted any further,
replace the press roller scraper.
7.
Remove the nut and washer.
8.
Replace the depth control wheel scraper.
9.
Install the washer and nut.
10.
To check the distance,
rotate the wheel.
10.2.6 Checking the RoTeC depth control discs and RoTeC depth control wheels
INTERVAL
at the end of the season
1.
Check the RoTeC depth control discs or RoTeC
depth control wheels for damage such as cracks
or fractures.
2.
If a RoTeC depth control disc or RoTeC depth
control wheel is damaged,
replace the RoTeC depth control disc or RoTeC
depth control wheel.
CMS-T-00006349-C.1
10 | Repairing the implement
Maintaining the implement
MG7508-EN-GB | B.1 | 31.08.2022 | © AMAZONE
123
