10.2.2
Checking the TwinTeC cutting disc
distance
10.2.3
Checking the TwinTeC depth control
wheel
10.2.4
Checking the TwinTeC cutting discs
10.2.5
Checking the TwinTeC depth control
wheel scraper
10.2.6
Checking the RoTeC depth control
discs and RoTeC depth control
wheels
10.2.7
Checking the RoTeC furrow former
10.2.8
Checking the RoTeC cutting discs
10.2.9
Checking the tightening torque for
the radar sensor bolts
10.2.10
10.2.11
Cleaning the cyclone separator
10.2.12
Cleaning the segment distributor
head
10.2.13
10.2.14
10.2.15
Checking the top link pin and lower
link pin
10.2.16
Checking the hydraulic hose lines
10.3
10.3.1
Overview of lubrication points
11.1
Installing a lashing point in the
hopper
11.2
11.3
12 Appendix
12.1
12.2
13 Directories
13.1
13.2
TABLE OF CONTENTS
MG7508-EN-GB | B.1 | 31.08.2022 | © AMAZONE
III
