6.4.9 Adjusting the placement depth on the RoTeC coulter
The placement depth can be adjusted in three stages
2
. The higher the position of the depth control discs
or depth control wheels, the greater the placement
depth. The greatest placement depth is achieved
when the depth control discs or depth control wheels
are completely removed.
NOTE
The adjustment of the seed placement depth must
be adapted to the respective operating conditions.
The optimum adjustment can only be determined
during field operation.
2
3
1
CMS-I-00004587
1.
Pull on the lever
1
for the depth control disc
or depth control wheel, move it up or down and
engage it in the desired position
or
To completely remove the depth control disc or
depth control wheel,
move the lever all the way down and push it
to the rear in the elongated slot
3
until the
depth control disc or depth control wheel can be
removed.
2.
Set all of the depth control discs or depth control
wheels at the same height or remove them
completely.
3.
To check the adjustment of the placement depth
on the field,
seed for approx. 30 m at working speed and
then check the work pattern, see "Checking the
placement depth".
4.
If the required placement depth has not yet
been reached, the coulter pressure must also be
adjusted, see "Adjusting the coulter pressure on
the RoTeC coulter".
CMS-T-00010255-A.1
6 | Preparing the implement
Preparing the implement for operation
MG7508-EN-GB | B.1 | 31.08.2022 | © AMAZONE
65
