Adjustments
94
Citan BAG0014.4 09.14
8.9
Roller harrow
DANGER
Make adjustments only when the tractor parking brake is applied, the
engine switched off and the ignition key removed
.
8.9.1
Adjusting working depth and arrangement angle of harrow tines
1. Raise the implement by the integrated running gear just so that
the harrow tines are immediately above the ground but not
touching it.
2. Apply the tractor parking brake, switch off the tractor engine and
remove the ignition key.
3. Hold the harrow tine bar by the carrier arm
(Fig. 90/3).
4. Adjust the working depth of the harrow tines
by securing the carrier arm with the pin (Fig.
90/1).
ο
in all segments
ο
in the same hole.
Fig. 90
The deeper the pin is inserted in the
adjusting segment, the greater the
work depth.
5. After each repositioning, secure the pin with
a safety splint.
6. Alter the arrangement angle of the tines to
the ground by securing the pin (Fig. 90/2)
ο
in all segments
ο
in the same hole.
Ensure that the pin (Fig. 90/2) is positioned
below the carrier arm (Fig. 90/3) in the ad-
juster segment.
The deeper the pin (Fig. 90/2) is in-
serted in the adjuster segment, the
flatter the angle.
7. After each repositioning, secure the pin
(Fig. 90/2) with a safety splint.
8. Move in the integrated running gear, i.e.
lower the machine fully.
