Adjustments
Citan BAG0014.4 09.14
97
8.10.2.1 Setting the exact harrow
Setting the harrow pressure:
1. Apply the parking brake, stop the tractor
engine and remove the ignition key.
2. Tension the lever (Fig. 94/1) with the aid of
the calibration crank.
3. Insert the pin (Fig. 94/2) into a hole under-
neath the lever.
4. Slacken the lever.
5. Secure the pin using a lynch pin.
Fig. 94
8.10.2.2 Setting the exact following harrow pressure
Important!
The hydraulic coulter presssure adjustment is coupled with the
hydraulic exact harrow pressure adjustment (if existent). If more
coulter pressure is applied, the exact harrow pressure is auto-
matically increased.
Setting the exact harrow pressure:
: Set the hydraulic hand lever 1 to B
(Fig. 95).
AMATRON 3: "Machine folding" must not be
switched on.
1. By actuating the tractor control valve the
hydraulic ram is
ο
pressurised or.
ο
set in the float position.
2. Apply the parking brake, stop the tractor
engine and remove the ignition key..
3. Insert each one pin (Fig. 96/2) into the
setting segment above and below the lev-
er and secure using clip pins.
Fig. 95
Fig. 96
