General Safety Information
28
Centaya Super BAH0092-6 10.20
Implement transportation
When using public roads, national road traffic regulations must be observed.
Switch off the control terminal before road transport.
Before road transport, check
that the supply lines are connected correctly
the lighting system for damage, function and cleanliness
the brake and hydraulic system for visible damage
whether the tractor parking brake is completely released.
the function of the brake system.
Always ensure that the tractor has sufficient steering and braking power.
Any implements and front/rear weights connected to the tractor influence the driving behaviour
and the steering and braking power of the tractor.
If necessary, use front weights.
The tractor front axle must always be loaded with at least 20 % of the empty tractor weight to
ensure sufficient steering power.
Always properly fasten the front or rear weights to the intended fastening points.
Comply with the maximum payload of the mounted/towed implement and the permissible axle
and drawbar loads of the tractor.
The tractor must guarantee the prescribed brake delay for the loaded vehicle combination (tractor
plus mounted/towed implement).
Check the brake power before moving off.
When turning corners with the mounted or towed implement, take the wide sweep and centrifugal
mass of the implement into account.
Before transporting the implement, ensure sufficient side locking of the tractor lower links if the
implement is attached to the three-point hydraulic system or lower links of the tractor.
Before road transport, move all the swivel implement parts to the transport position.
Before road transport, secure all the swivel implement parts in the transport position against risky
position changes. Use the transport locks intended for this.
Before road transport, lock the operating lever of the tractor's three-point hydraulic system
against the unintentional raising or lowering of the mounted or towed implement.
Before road transport, check that the required transport equipment, e.g., lighting, warning
equipment and protective equipment, is correctly installed on the implement.
Before road transport, perform a visual check that the top and lower link pins are firmly fixed with
the linch pin against unintentional release.
Adjust your forward speed to the respective prevailing conditions.
Before driving downhill, switch to a lower gear.
Before road transport, always switch off the independent wheel braking (lock the pedals).
Observe the maximum permissible total weight.
Summary of Contents for Amazone Centaya 3000 Super 1600
