User manual
Point cloud measurements
© Amberg Technologies, 2018
Page 23 of 68
Set proposed sphere position
Detect the spere position wit the automatic sphere
search algorithm.
Zoom 1:1
Shows a window with the selected sphere.
Zoom to fit
Shows the hole scan in one picture.
OK
Uses the selected sphere for the resection calculation of
the scan.
The position information of the point cloud are visible in the property window.
3.8.3 Reposition with checkerboard or sphere targets
The steps of the
Reposition of the point cloud with checkerboard / sphere targets
for point
cloud data wizard are described following.
1. Select the state (date and time) at which the control point coordinates should be used.
2. Mark the center of the targets with manually click to the target center. Use the
Insert point
function
in the menu. If minimum 3 points with valid control point coordinates are selected
the software will identify the used control points and label the point number automatically.
Figure 9. Reposition point cloud data wizard, checkerboard selection
Zoom 1:1
Shows a window with the selected target.
Zoom to fit
Shows the whole scan in one picture.
Summary of Contents for Tunnel 2.0 - Tunnelscan
