9
1.
Make sure the popcorn maker is unplugged before you do any of the following:
2.
Before using the unit, please check carefully to be sure voltage
(AC120V~60Hz) is suitable to your home.
3.
Clean the popcorn maker as described under the "Care and cleaning" section.
4.
The main popcorn unit has 2 function switches as follows:
LIGHT:
to turn the internal light bulb on.
POP:
to turn the stirring stick motor & heater on.
5.
Ensure the Kettle Popcorn Maker is fully assembled. (See page 8 for assembly)
6.
Plug the external power cord into an electric wall outlet.
7.
Before pouring oil or kernels into the kettle, lift lid using the lid tab. Add oil
(1 tablespoon of vegetable, corn, peanut, or coconut oil).
NEVER
use butter or margarine in the kettle when popping kernels. This will
cause the popcorn to burn and create an unpleasant residue.
8.
Turn both 'LIGHT' & 'POP switches to 'ON' position. The light, heater and motor
will be on. Let the kettle preheat the oil for approximately 2 to 3 minutes.
9.
Turn the 'POP' switch to off position and add 1/3 cup of corn kernels (1/3
measuring cup included) and close the door.
10.
Turn the 'POP' switch back on, the stirrer will begin to rotate and the heater will
begin to heat up the oil and corn.
The popcorn maker will be hot; we recommend using oven mitts to handle all
components of the hot popcorn maker.
The popcorn will begin to start popping out through the kettle after approx. 2
minutes.
Using Your Kettle Popcorn Maker
Instructions
