Main Specifications
Headphone
Type
: Dynamic
Driver unit
: 9 mm, dome type
(CCAW voice coil)
Maximum input
: 100 mW
(IEC*)
Impedance
: 16 Ω (at 1 kHz)
Cable
: Approx. 1.2 m, Y type
Plug
: Metal-plated I-type 4-pin
mini-plug
Weight
: Approx. 5.2 g
(excluding cable)
Microphone
Type
: Electret condenser
Directionality
: Omnidirectional
Open circuit voltage level
: –40
dB (0 dB = 1 V/Pa)
Effective frequency range
: 20
Hz to 20 kHz
· Values are measured in
accordance with IEC
(International Electrotechnical
Commission) standards.
Note that the specifications and
appearance of this device are
subject to change without
notice in order to make
improvements.
Cautions for use
· This device is a precision device.
It should be treated gently and
should not be dropped or
crushed.
· Do not place in locations with
lots of humidity, dust, smoke, or
steam, and do not place in direct
sunlight.
· Occasionally clean the unit and
plug by wiping with a soft, dry
cloth.
· Do not blow on the unit.
· If the earpieces are difficult to
remove, it may be easier to grasp
them with a soft, dry cloth.
· If the earpieces become dirty,
remove them from the main body
and then hand wash them using
dilute neutral detergent. After
washing, wipe away any moisture
before re-attaching.
· You may feel tingling in your ear
due to static electricity building
up on your body. This can be
reduced by wearing clothing
made from natural fibers.
The earpieces are replaceable.
Check the following website for
information to purchase
earpieces and accessories.
https://ambiesound.com
