50D0112
RCSTEBA Installation & Operating Manual
Rel 1.0 April 2009
Page 2 of 10
Ambient Technologies
A Division Of
Monessen Hearth Systems
WARNING
Important Safety Information
•
Read this manual thoroughly prior to installing, programming or operating any remote control.
•
This remote control system is designed for use with a millivolt gas valve system with blower. Do not use
this remote control system on applications with voltages above 24 Volts AC/DC and 1 amp current.
•
This remote control system requires three (3) “AAA” alkaline batteries to power the transmitter. The
receiver is powered by external AC Adapter.
•
Wiring must conform to appliance requirement and building codes/ordinances as required by local and
national code authorities having jurisdiction.
•
Do not short (or jumper) across the gas valve terminals to test the remote control installation. This could
damage the unit and void the warranty.
•
This remote control system should only be used as described in this manual. Any other use is not
recommended and will void the warranty.
NO
TE
Due to the sensitive temperature monitoring components in the transmitter, it is necessary to
allow the transmitter to stabilize to room temperature before accurate room temperatures are
displayed. If the transmitter is activated from a severe cold condition, allow 15 minutes for
accurate temperature readings to appear on the LCD.
WARN
IN
G
Turn appliance OFF and allow to cool before installing or servicing. DO NOT connect
110-120 VAC wiring to the milli-volt gas control valve. The remote operator must be installed
exactly as outlined in these instructions. Read all instructions completely before attempting
installation. Follow instructions carefully during installation. Any modification of
components will void the warranty and may cause a fire hazard.
WARNIN
G
Turn appliance OFF (at the appliance or remote receiver) if you are away from your house for
an extended period of time. Never leave anything on top of the surface of the transmitter.
INSTALLATIONS
Remote Receiver:
The remote receiver may be installed in the appliance per the appliance homeowner’s manual.
Refer to the
Homeowner’s Manual for special installation instructions.
Failure to follow the installation instructions found
in the appropriate Homeowner’s Manual will void the warranty and may cause a fire hazard.
This system comes with an 22 inch wire assembly labled “MV VALVE”. Insert the white terminal into the back of
the receiver. The terminal wire block can only be installed one way and do not force the terminal plug into the
receiver.
