Version 1.1
©Copyright 2014, Ambient LLC. All Rights Reserved.
Page 6
Figure 7
4
Console Operation
Note:
The console has three buttons for easy operation:
SET
,
CH/+
and
MIN/MAX
button. The
remaining two buttons have no functionality (the same console is used for different products and
therefore, are not used for this product).
4.1
Set Mode
To enter the Set mode, press and hold the
SET
key for 3 seconds.
1.
12/24 Hour.
12 Hr or 24 hour will begin flashing.
Press the
CH/+
button to switch between
12 hour and 24 hour display mode. Press the
SET
button (do not hold) to advance to the next
setting.
2.
Hour of Day.
The hour of day will begin flashing. Press the
CH/+
button to increase the hour,
and the
MIN/MAX
key to decrease the hour. Press the
SET
button (do not hold) to advance
to the next setting.
3.
Minute of Day.
The minute of day will begin flashing. Press the
CH/+
button to increase the
minute, and the
MIN/MAX
button to decrease the minute. Press the
SET
button (do not hold)
to advance to the next setting.
4.
Temperature Units of Measure.
The °F or °C icon will begin flashing. Press the
CH/+
button to switch between °F and °C. Press the
SET
button (do not hold) to exist the Set
Mode.
4.2
Min/Max Mode
The Min/Max mode displays the minimum and maximum indoor and outdoor temperature and indoor
humidity (since reset of the unit) for the indoor, remote channel 1, 2 and 3 sensors.
Prior to entering the MIN/MAX mode, press the
CH/+
button to select the temperature values you
wish to view.
1.
Display Maximum
. Press the
MIN/MAX
button once to display the maximum. The
MAX
icon will be displayed.
2.
Clear Maximum.
To reset the maximum values to the current values,
press and hold
the
MIN/MAX
key for 3 seconds.
3.
Display Minimum
. Press the
MIN/MAX
button again to display the minimum. The
MIN
icon will be displayed.
4.
Clear Minimum.
To reset the minimum values to the current values,
press and hold
the
MIN/MAX
key for 3 seconds.
To return to normal mode, press the
MIN/MAX
button again, or wait 15 seconds for timeout.
4.3
Indoor/Outdoor Channel Selection
Press the
CH/+
button to switch the display between OUT remote sensors 1,2 and 3. Channel 1 is
included with the unit. Channels 2 and 3 are optional sensors and purchased separately.
4.4
Sensor Search Mode
If any of the sensor communication is lost, dashes (--.-) will be displayed on the screen. To reacquire
the signal, press and hold the
CH/+
button for 3 seconds, and the remote search icon
will be
constantly displayed. Once the signal is reacquired, the remote search icon
will turn off, and the
