Version 1.0
©Copyright 2017, Ambient LLC. All Rights Reserved.
Page 7
Do not touch any buttons until the remote sensor has reported in, or the radio search icon
is no longer constantly on, otherwise the remote sensor search mode will be terminated.
When the remote sensor temperature has been received, the console will automatically
switch to the normal mode, and all further settings can be performed.
If the remote does not update, please reference the troubleshooting guide in Section 8.
4.1 Display Console Layout
Figure 6
4.2 Sensor Operation Verification
Verify the indoor and outdoor temperature match closely in the same location (about 5 to 10’ apart).
The sensors should be within 2°F (the accuracy is ± 1°F). Allow about 30 minutes for both sensors
to stabilize. The temperature can be adjusted or calibrated later to match each other or a known source.
