Version 1.1
©Copyright 2014, Ambient LLC. All Rights Reserved.
Page 10
will automatically toggle between sensors until all sensors have reported in.
Do not touch any buttons until the remote sensor has reported in, or the radio search icon
is no longer constantly on, otherwise the remote sensor search mode will be terminated.
When the remote sensor temperature has been received, the console will automatically
switch to the normal mode, and all further settings can be performed.
If the remote does not update, please reference the troubleshooting guide in Section 8.
4.1 Display Console Layout
Figure 11
4.2 Sensor Operation Verification
Verify the indoor and floating pool temperature match closely in the same location (about 5 to 10’
apart). The sensors should be within 2°F (the accuracy is ± 1°F). Allow about 30 minutes for both
sensors to stabilize. The temperature can be adjusted or calibrated later to match each other or a
known source.
5
Display Features
5.1 Rate of Change Icon
The rate of change icon
detects rapid changes in remote temperature. If the arrow points
upward, the temperature is increasing at a rate of +2°F per 30 minutes (or greater), If the arrow points
downward, the temperature is decreasing at a rate of -2°F per 30 minutes (or less).
