Version 1.1
©Copyright 2014, Ambient LLC. All Rights Reserved.
Page 11
5.2 Console Operation
Note:
The console has three buttons for easy operation:
SET
button,
MIN/MAX
button, and
CH/+
button.
5.2.1 Set Mode
The Set Mode allows you to set the time and time format, time alarm and units of measure.
To enter the set mode, press and hold the
SET
key for 3 seconds.
1.
12 hr/24 hr time format.
Press the [+] key to switch between 12 and 24 hour format. Press
the SET key to advance to the next setting.
2.
Hour
. Press the [+] or [-] key to increase or decrease the hour. Press the
SET
key to
advance to the next setting.
3.
Minute
. Press the [+] or [-] key to increase or decrease the minute. Press the
SET
key to
advance to the next setting.
4.
Alarm
Hour
. Press the [+] or [-] key to increase or decrease the alarm hour. While the alarm
value is flashing, press and hold the
SET
button for three seconds to toggle the alarm on and
the alarm off. The time alarm icon will appear
when set, and disappear when disabled.
Press (do not hold) the
SET
key to advance to the next setting.
5.
Alarm
Minute
. Press the [+] or [-] key to increase or decrease the alarm minute. While the
alarm value is flashing, press and hold the
SET
button for three seconds to toggle the alarm
on and the alarm off. The time alarm icon will appear
when set, and disappear when
disabled. Press(do not hold) the
SET
key to advance to the next setting.
6.
Temperature Units of Measure
. Press the
[+]
key to switch between °F and °C units of
measure. Press the
SET
key to advance to the next setting.
7.
Max/Min Clearing
. The Max/Min can be programmed to clear daily (at midnight) or
manually. Press the
[+]
key to switch between “Clears Daily” and Clears Manually. Press the
SET
key to exit setting.
5.2.2 Viewing the High and Low Alarms
The high and low alarms can be set for Channels 1 and 2 only. Press the
CH/+
button to switch the
display between Channel 1 and 2.
Next, press the
SET
button to view the High
(MAX)
and LOW
(MIN)
alarm along with the alarm
time. Press the
SET
button again to return to the normal mode.
5.2.3 Alarm Defaults
Channel Default Condition HI ALARM (temperature) ºF
LOW ALARM (temperature)ºF
1
OFF
100
60
2
OFF
110
90
5.2.4
Setting the Min and Max Alarm
The high and low alarms can be set for Channels 1 and 2 only. Press the
CH/+
button to switch the
display between Channel 1 and 2.
Next, press the
SET
button once, and the alarm icon will appear:
. Press and hold the
SET
button for 3 seconds, and the temperature
HIGH (max)
alarm will flash. Press the
CH/+
button to
increase the
HIGH
alarm and the
MIN/MAX
button to decrease the
HIGH
alarm. Press and hold the
+ or - button to change rapidly. While the alarm value is flashing, press and hold the
SET
button for
