Version 1.0
©Copyright 2015, Ambient LLC. All Rights Reserved.
Page 3
1.
Remove the battery door on the back of the sensor by removing the set screw, as shown in
Figure 1 .
Figure 1
2.
BEFORE
inserting the batteries, locate the dip switches on the inside cover of the lid of the
transmitter.
Figure 2 displays all four switches in the OFF position (factory default setting).
Figure 2
3.
Channel Number:
The WS-70 supports up to eight transmitters. To set each channel number
(the default is Channel 1), change Dip Switches 1, 2 and 3, as referenced in Table 1.
4.
Temperature Units of Measure:
To change the transmitter display units of measure (°F
vs. °C), change Dip Switch 4, as referenced in Table 1.
