Version 1.0
©Copyright 2015, Ambient LLC. All Rights Reserved.
Page 6
Figure 5
1. Indoor Temperature
2. Temperature units (°F or °C)
3. Indoor Relative Humidity (%)
4. Min/Max reset for 24h
5. Min/Max Record mode
6. Outdoor Relative Humidity (%)
7. Outdoor Temperature
8. Channel 1,2,3,4,5,6,7,8, indictor
9. Scroll mode (CH1-8)
2.3.2
Sensor Operation Verification
Verify the indoor and outdoor humidity match closely with the console and sensor array in the same
location (about 5 to 10’ apart). The sensors should be within 10% (the accuracy is ± 5%). Allow
about 30 minutes for both sensors to stabilize. The humidity can be adjusted or calibrated later to
match each other a known source.
Verify the indoor and outdoor temperature match closely with the console and sensor array in the same
location (about 5 to 10’ apart). The sensors should be within 2°F (the accuracy is ± 1°F). Allow
about 30 minutes for both sensors to stabilize. The temperature can be adjusted or calibrated later to
match each other or a known source.
3
Remote Sensor Installation
It is recommended you mount the remote sensor on a north facing wall, in a shaded area. Direct
sunlight and radiant heat sources will result in inaccurate temperature readings. Although the sensor is
water resistant, it is best to mount in a well protected area, such as under an eve. Use a screw or nail
