experience quality.
UMP II
©2014, Ambient Recording GmbH
4
Start Up
Select Phantom 48/ 12V
You can change Phantom power 48Volt to
Phantom power 12Volt via internal switch.
Open the battery flap.
Remove the battery with the minus pole outside.
Now you can see the switch.
Use a small flat-headed screwdriver to change the switch-position
but please take care that you don’t scratch the PCB.
Insert Batteries
The UMP II is powered by two 1.5Volt AA-batteries.
Open the battery flap and insert the batteries.
Look to it that the polarity of the batteries is right.
Replace the battery flap.
Assembling the UMP II to the Mounting Plate (QWB)
Assemble the UMP II downwards on to the
“
QWB” mounting plate.
The audio-transmitter can be mounted on the
other side of the "QWB".
Install the cables er
take care that the cables will not produce background noise.
