experience quality.
UMP II
©2014, Ambient Recording GmbH
6
Switching ON/ OFF
Connect the microphone and the audio-transmitter.
Switch the selector switch to Phantom (
“
PH
”
) or T-power (
“
T
”
).
Which position depends on which microphone is in use.
Switch position PH: Phantom-power
Switch position T T-power
Middle-position: OFF
Please take care of PH48V or PH12V
– switchable with the internal switch.
After switching on, the Mode LED will light up in the
corresponding color.
If the LED´s don’t light up, please control the microphone connection, the operation
mode and the batteries.
LED - Display
OFF, no microphone is connected
Battery OK, Phantom 48V (blue LED)
Battery OK, Phantom 12V (yellow LED)
Battery OK, T-Power (green LED)
LOW Battery, (Phantom 48V)
The
“
Mode
”
LED just light up when the microphone is connected and the selector
switch is adjusted to
„
PH” or
„
T“.
