Ambros Huber
∙ Am Graben 8 ∙ 83128 Halfing ∙ Germany
∙
O -
Rubber-stopper
Ambros Huber
Am Graben 8
83128 Halfing
Germany
USER MANUAL
Charging
-
The lamp is off
-
Remove the rubber-stopper (
O
) and insert it in the free hole in the hanger
at the base of the lamp.
-
Connect the solar panel
’s charging cable with the power jack (
I
) of the lamp.
-
Avoid temperatures over +45 °C during charging process. Do not expose
the lamp to direct sun light!
-
At the beginning of charging the small LED indicator light in the
dome
flashes
fast green
-
When fully charged, the small indicator light in the dome is
solid green
.
-
Unplug the charging cable from the power jack.
Do not pull on the cable!
-
Attention! Short circuit! Protect the power jack against contamination.
Clean only with a non-conductive object.
-
Re-insert the rubber stopper (
O
) into the power jack (
I
).
Discharge (Using lamp)
Press button (
N
) 1 time
mid brightness level
Press button (
N
) again
max brightness level
Press button (
N
) again
min brightness level
Press button (
N
) again
lamp off
-
The lamp can be used in any orientation
-
For writing and reading hang the lamp about 25 inches above the work surface to avoid glare. Therefore
unfold the hanger at the bottom of the lamp.
-
For room lightning hang the lamp higher.
-
Keep the lamp dome clean and protect it against mechanical damage (scratches).
-
Clean the lamp dome with a soft, damp cloth. Do not use cleaning agents!
Battery:
The lamp is equipped with a lithium-ion battery. Nominal
voltage 3.7 V, capacity 4400 mAh
-
Operating temperatures over 65 ° should be avoided,
cool storage is advantageous.
-
Store the battery (in the lamp) in a partially
charged state
if possible
-
Charge the lamp at least once a year to prevent deep
discharge
-
When the lamp was not used for a long time, up to two full
cycles (charge/discharge) may be necessary so that the
battery has full power again.
Disposal:
Send the lamp together with the solar panel to the manufacturer!
The lamp may not be disposed of in municipal waste!
If you remove the light dome, the warranty will expire!
N
- Button
I
- Power jack
