Operation
•
Before the start please ensure that amplifier power is off.
•
Connect sources such as CD player, DVD player or microphone into amplifier’s inputs.
•
Select bridge or stereo function by bridge/stereo switch.
•
Connect the outputs from the unit to your speaker. The stereo and bridge outputs are labeled
on the panel.
•
We recommend enabling Limiter.
•
Set the volumes controls into the “0” position and turn on the power.
•
Now you can adjust needful volume and tone levels.
Limiter
The limiter is a function that prevents very loud signals from passing through it by limiting the signal
volume temporarily to a normal level. Limiter prevents damage to the speakers or the unit itself.
The limiters primary function is to help prevent one time very loud signals such as a dropping of a
microphone or short loud parts of the music signals. Turning the limiter on may helps protect from sort
overloud, but it is not intended for total dynamics control.
Installation
Troubleshooting
No power
Check power adaptor and power cable.
If power supply is good and LED of the
supply is lighting check the amplifier. If
not, please change power supply.
No sound
Check speaker’s line maybe line is
overloud and simultaneously check
maybe speakers is in short circuit.
Very high
noise
level
Check the connections of the devices,
and check signal level maybe level of the
input signal is too big. Make sure that
amplifier is not overloading.
