13
12
1
2
3
4
5
15.0 cm
10.5 cm
4.3 mm
A
1
2
4
3
C
E
B
D
F
G
H
5. Maintenance
and care
Before each cleaning, pull out the
power cord from the socket.
Let the Navigenio cool down before
cleaning and storing.
Never immerse the Navigenio in water
or put in dishwasher.
Never use organic solvents or petrol.
Likewise, the following are unsuitable
for cleaning:
• abrasive cleaning material and scou-
ring agents in powder or liquid form
• saponified steel wool
• coarse abrasive side of sponges
• hand wash pastes
Maintain and care for the Navigenio as follows:
Clean after every use.
Sugar, sugar-containing and sour dishes as well
as aluminium can damage the glass-ceramic
surface, hence remove immediately.
Remove burnt food particles on the glass-cera-
mic cooking zone with a glass-ceramic scraper.
Clean handle and plastic parts with a moist
cloth and a mild detergent. We recommend
Magic Foam.
Remove stubborn stains with Magic Stone.
The glass-ceramic cooking zone can be
re-polished with Magic Stone.
Sand and similar dirt can cause scratches on
the glass-ceramic surface and the base of the
pot, hence remove immediately.
Remove food that is boiling over immediately.
6. Technical
data
Model C8100
Voltage 220–240 V
Frequency 50/60 Hz
Power 1800 W
Diameter of heating circuit 18 cm
Marking
4. Magnet holder
assembly
(optional accessories)
There are 4 strong magnets in the magnet
holder. These can damage TVs, laptops,
computer, hard disks, credit cards and
debit cards, data mediums, mechanical
clocks, hearing aids and loudspeakers.
Take particular care with pacemakers and
implanted defibrillators. Make sure to have
a distance of minimum 20 cm.
1 Screw
2 Dowel
3 Washer
4
Magnet holder
5
Cover plate
Assembly with gluing
The attachment point (wall) has to be clean,
fat free and dry. The attachment per sticky tape
is recommended for plain surfaces. For this the
sticky tape on the back of the magnet holder
can be used.
A
Measure height (Lower edge of magnet
holder to tabletop 10.5 cm, screw hole
to tabletop 15.0 cm).
D
Peel off sticky tape on the back and
press it firmly at the wall.
F,G,H
Place Navigenio with the stainless steel
surface on the back at the magnet
holder, so that Navigenio is standing
on the kitchen tabletop – not
free-floating! (G,H)
Assembly with screwing
The attachment point (wall) has to be clean,
fat free and dry. The attachment per screw is
recommended for rough or rugged surfaces
(wooden or plastered walls).
A
Measure height (Lower edge of magnet
holder to tabletop 10.5 cm, screw hole
to tabletop 15.0 cm).
B
Remove cover plate
C
Drill a hole in the wall with a drilling
machine (Drilling machine diameter
5 mm) (1), insert dowel (2), peel off
sticky tape on the back (D), drill magnet
holder with washer (3) and screw (4) on
the wall so that Navigenio is standing
on the kitchen tabletop – not
free-floating!(G,H)
E
Refit cover plate
