20 Gear Drive, Plymouth Ind. Park, Terryville, CT 06786
Tel: (860) 585-1254 Fax: (860) 584-1973 http://www.amci.com
NXEE2 User Manual
S
ET
THE
IP A
DDRESS
AND
P
ROTOCOL
37
2.2c Use the AMCI Net Configurator Utility (continued)
2.2c.3 Verify that Your Host Controller is Disconnected from the NXEE2
In order to program the NXEE2, the AMCI Net Configurator utility must act as a bus master. Therefore, phys-
ically disconnect your host controller from the NXEE2 before starting the Net Configurator utility. Conflict-
ing commands from the Net Configurator utility and the host controller will prevent the NXEE2 from
communicating properly with either bus master.
2.2c.4 Apply or Cycle Power to the NXEE2
Cycling power to the NXEE2 will reset any connections it may have with the host controller.
2.2c.5 Start the AMCI Net Configurator Utility
Double click on the utility’s icon. A welcome screen similar to the one in figure T2.4 below will appear.
Figure T2.4 Net Configurator Welcome Screen
Summary of Contents for NXEE2
