40
Send Email:
This checkbox allows the user to enable the camera to send an email when an IVS event is triggered.
Snapshot
: This checkbox allows a snapshot of the IVS event to be sent via Email when triggered.
Draw Rule
: This option allows the user to use their mouse to customize (draw) a rule/area on the screen. This will
be the area or line in which an IVS rule will be triggered.
Clear:
This option is used to clear the drawn rule set on the live monitor screen.
Target filter:
Sets a maximum and minimum size in which an event will be triggered.
Clear:
Clears the modified target area to draw the target area on the live monitoring screen.
Draw Target:
Allows the user to set a target area on the live monitor screen.
An IVS event will not occur outside
the target box.
Pixel Counter
: Used to measure and set the number of pixels in the target area on the live monitoring screen.
To reset to default settings, click the
Reset Defaults
button. To refresh the page, click the
Refresh
button. To save
the settings, click the
Save
button.
Setting a Tripwire
1.
Select Tripwire from the
Rule Type
drop down menu. Set a name for the rule by double clicking the mouse over
the Name of the rule.
2.
Click on
Setup
to set a schedule, set your periods (if any) and click
Save
to continue.
3.
In the
Direction
menu, choose which direction the object will be going for the tripwire to be triggered.
4.
Enable the Record checkbox to record the event.
5.
Check the
Send Email
and
Snapshot
checkboxes if you would like a snapshot of the event emailed to you. A valid
Email address must be established in the camera prior to enabling this setting.
6.
Click the
Draw Rule
option and use your mouse to draw the rule on the live monitoring screen. Once the rule
has been drawn click the monitoring screen to finish setting the rule. The drawn line will turn blue/green when
set depending on the browser you are using.
Note:
The target filtering and pixel counter can be used to refine the set rule however for optimal experience it is
highly recommended to leave these settings as default
To reset to default settings, click the
Reset Defaults
button. To refresh the page, click the
Refresh
button. To save
the settings, click the
Save
button.
Intrusion
Intrusion allows the camera to trigger an event if an object, such as a human or vehicle, appears or crosses a set
intrusion area set by the user. Below is a screenshot of the Intrusion menu:
