5
Chapter 2
Hardware Installation
2-1 Install Socket AM2 Supported AMD Processor
This motherboard provides a 940-pin surface mount, Zero Insertion Force (ZIF) socket,
referred to as the mPGA940 socket supports AMD Athlon64 processor in the 940 Pin package
utilizes Flip-Chip Pin Grid Array package technology.
The CPU that comes with the motherboard should have a cooling FAN attached to prevent
overheating. If this is not the case, then purchase a correct cooling FAN before you turn on
your system.
WARNING!
Be sure that there is sufficient air circulation across the processor’s
heatsink and CPU cooling FAN is working correctly, otherwise it may
cause the processor and motherboard overheat and damage, you may install
an auxiliary cooling FAN, if necessary.
To install a CPU, first turn off your system and remove its cover. Locate the ZIF socket and
open it by first pulling the level sideways away from the socket then upward to a 90-degree
angle. Insert the CPU with the correct orientation as shown below. The notched corner
should point toward the end of the level. Because the CPU has a corner pin for two of the
four corners, the CPU will only fit in the orientation as shown.
CPU ZIF mPGAB Socket
Colden Arrow
S
o
ck
et
AM
2
When you put the CPU into the ZIF socket
，
No force require to insert of the CPU, then press
the level to Locate position slightly without any extra force.
2-4
Install
Memory
This motherboard provides four 240-pin DDR2 DUAL INLINE MEMORY MODULES
(DIMM) socket for DDR2 memory expansion available from minimum memory volume of
128MB to maximum memory volume of 8.0GB DDR SDRAM.
Valid Memory Configurations
Bank
240-Pin DIMM
PCS
Total Memory
Bank 0, 1 (DIMM1)
DDR2 533/DDR2 667/DDR2 800
X1
128MB
∼
2.0GB
Bank 2, 3 (DIMM2)
DDR2 533/DDR2 667/DDR2 800
X1
128MB
∼
2.0GB
Bank 4, 5 (DIMM3)
DDR2 533/DDR2 667/DDR2 800
X1
128MB
∼
2.0GB
Bank 6,7 (DIMM4)
DDR2 533/DDR2 667/DDR2 800
X1
128MB
∼
2.0GB
Total
System Memory (Max. 8.0GB)
4
128MB
∼
8.0GB
