RECHARGABLE BATTERY PACK:
THE RECHARGEABLE BATTERY PACK IS A STANDARD FEATURE ON THE TECH-SCAN 32 PLUS ECU AND
PROVIDES YOU WITH UP TO EIGHT HOURS OF USE WITH A RECHARGING TIME OF APPROXIMATELY FOUR
HOURS. IT IS RECOMMENDED THAT THE UNIT BE FULLY CHARGED BEFORE USING FOR THE FIRST TIME.
1.
To charge the battery pack, plug the charging unit into an AC outlet.
2.
Plug the other end of the charger into the front of the Tech-Scan 32 Plus ECU. The charging LED will light, (RED for
charging).
3.
When the charging LED changes to GREEN, the battery pack is fully charged.
4.
It is recommended that the unit be recharged nightly.
RECORD OPERATION:
Note: It is important during any recording operation that the built in microphone, located on the front right hand corner of
the Tech-Scan 32 Plus ECU (see diagram – FRONT VIEW), is clear and open. For best results, place unit on a flat surface
with the microphone facing you and record all messages in a quiet room. Be sure that the External User switch is not plugged
into the unit while you are recording. It is recommended that you record all the Auditory Prompts at one time, then all the
Normal Messages at one time to prevent having to switch back and forth between the 2 modes.
1.
Turn the Tech-Scan 32 Plus ECU ON by turning the
VOLUME
control switch clockwise, until it clicks ON.
2.
Select the
LEVEL
you wish to record on by turning the level selector switch to one of the six levels.
3.
Set the
PROGRAM
switch to the type of message that you wish to record on AUDITORY, NORMAL, or ROW prompt
(see diagram – BACK VIEW).
Programming the Auditory Prompts
:
1.
Set the
Program
Mode select switch to the left position labeled
AUDI
, you will be recording the auditory prompts. These
prompts have a maximum message length of 1.5 seconds.
2.
Press and hold in the built-in record switch.
The record switch must be engaged for the entire recording process.
3.
Select one of the 32 message squares on the face of the Tech-Scan 32 Plus ECU, press and hold down that message square.
Then begin to say your message into the built in microphone located at the front right hand corner of the Tech-Scan 32 Plus
ECU.
4.
Release the message square when you are finished recording that message.
5.
Repeat steps 2 through 4 for the remaining message squares.
Programming the Normal Messages:
1.
Set the
Program
Mode select switch into the middle position, marked
NORMAL
, you will be recording the full message
itself; follow steps above (Programming the Auditory Prompts) 2 to 4 to program each message. These messages have a
maximum message length of 3.0 seconds for standard units and 7.5 seconds for extended time units.
Programming the Row Prompts:
1.
Set the
Program
Mode select switch to the right position marked
ROW
, you will be recording the row titles. Follow steps
above (Programming the Auditory Prompts) 2 to 4 to program each row title, use the first message square in each row.
Maximum message length for each ROW prompt is 1.5 seconds.
