The Model A220FP Fragrance Injector Pump is to be used with the AK and 3K steamers when the K200i Freedom
Control is not installed. The pump should be mounted in an easily accessible area, not more than 4' above the essence
container and not more than 4' below the saddle valve. The on/off switch located on the side of the fragrance injector
pump must be turned on and remain in the on position.
4211-189 08-09-11
DIAGRAM
1
WARNINGS
The use of fragrance oils may introduce excessive concentration of oil into the steam room, resulting in a health
hazard.
Leave the room immediately if you have any adverse or allergic reactions, including difficulty breathing or eye, nasal,
throat or skin irritation, and seek immediate medical attention.
Vapors may cause drowsiness and dizziness. Keep out of the reach of children. In case of contact with eyes, rinse
immediately with plenty of water and seek medical advice. If swallowed, rinse mouth with water (only if person is
conscious) and seek medical advice immediately.
Essential oils may be highly flammable! Keep away from sources of ignition. No smoking! Keep container tightly closed
and in a well ventilated place.
Not for use in acrylic or fiberglass rooms.
The pump has been factory set to deliver a suitable amount of aromatic oil into a typical sized steam room. Use
caution when increasing the speed on the pump as this may introduce excessive concentration of oil into the steam
room, resulting in a health hazard.
A220FP Fragrance Injector Pump
Installation and Operating Instructions
AK Steam
Generator
Fragrance
Injector Pump
Saddle Valve (supplied)
Mount on top of Steam Line
Essence Container
(supplied)
Thermal Switch
(supplied)
Mount on top
of Steam Line
120VAC - 24VAC
Power Adapter
Fragrance
Controlller
Clear
Tubing
(supplied)
On/Off
Switch
3' Min.
Installation Overview
Summary of Contents for A220FP
Page 1: ......
