MAINTENANCE
DANGER
ALWAYS SHUT OFF THE FAN AND UNPLUG
IT FROM ITS POWER SOURCE TO PREVENT
ACCIDENTAL STARTING AND THE
POSSIBILITY OF ELECTRICAL SHOCK
AND/OR ELECTROCUTION. BE SURE THE
FAN BLADE HAS STOPPED ROTATING
BEFORE PLACING ANY OBJECTS OR
FINGERS NEAR THE FAN GRILL.
1. Visually check all fastners and individual
components for loose or broken parts. Tighten or
replace items, as required, only with genuine, factory
approved replacement parts.
2. Keep the Fan blade clean from debris.
Accumulation of dust, dirt, paint, etc. on the Fan
blade will throw the blade rotation out of balance
resulting in damage. To clean the Fan blade, be sure
the plug is disconnected and the blade has stopped
rotating. Remove one grill and wipe blade and interior
shell housing clean of debris with a damp cloth and
mild liquid soap. Dry all parts thoroughly.
DO NOT
PRESSURE WASH THE FAN.
Replace grill prior
to next operation.
DANGER
DO NOT OPERATE THE FAN WITHOUT THE
INLET AND OUTLET GRILL PROPERLY IN
PLACE.
3. Contact an Americ Authorized Service Center, or
Americ directly for Fan maintenance or repair not
described in this manual (or if you are unsure whether
maintenance is required.) at Tel# (847) 364-4646, or
at www.americ.com.
SERVICE
1) Refer to the TROUBLESHOOTING GUIDE in
this Manual.
MOTOR SPECIFICATIONS
Voltage
220/440-220/440
220
Phase
3PH: HZ:60/50
1PH: HZ:60
Amps
13/6.5
21.2
HP:
5/3
5
R.P.M
3495/2960
3250
Encl:
TENV
TENV
GENERAL INFORMATION & DIMENSIONS
Type
Axial
Duct adapter
20.5'' dia.
(52 cm)
Height
27.5''
(69.8 cm)
Width
25.5''
(64.7 cm)
Length
27.5''
(69.8 cm)
Weight
119 lbs
(53.97 kg)
AIR FLOW RATES (APPROXIMATE)
Feet
Description
CFM
M
3
/Min.
Free Air
7184
203
25' duct
Straight
7100
201
25' duct
1-90º bend
6693
189
25' duct
2-90º bends
6271
177
50' duct
Straight
6839
193
50' duct
1-90º bends
6494
183
50' duct
2-90º bends
6015
170
100' duct Straight
6681
189
CAUTION
THE AIR FLOW RATE DECREASES AS THE
LENGTH OF DUCT INCREASES FOR BOTH
BLOWING AND SUCTION APPLICATIONS. AIR
FLOW RATES WILL VARY WITH SPECIFIC DUCT
TYPES AND MANUFACTURES.
