Page -5-
Operation: R.E.S.C.U.E. Remote Control System
Unlocking Rear Door
Press
Button 1
to unlock rear door. When the radio frequency (RF) signal is received by the receiver, the relay
(supplied) energizes the factory electric door lock mechanism and then unlocks the door.
Opening Rear Door
Press
Button 2
to open the rear door. When the radio frequency (RF) signal is received by the receiver, the
actuator (supplied) unlatches the rear door, the gas strut pushes the door to the fully extended position to allow
the K9 to exit the vehicle.
Locking Rear Door
Press both buttons together to lock the rear door. The radio frequency (RF) signal is received by the receiver,
the relay (supplied) energizes the factory electric door lock mechanism and then locks the door.
Interference Warning
All RF signals are subject to
INTERFERENCE
- including but NOT limited to: other RF antennas, other
RF signals being broadcast at the same time, other RF devices (radios, radar devices), large pieces of metal or
metal buildings, large bundles of wire (inside a vehicle), switching power supplies, and motors of any kind.
The RF signal can pass through obstacles in the line of sight such as; wood, glass or plastic. RF signals cannot
pass through any type of metal or tinted windows which have been tinted with a metalized film. All factory
tinting & some aftermarket tinting use the metalized film technology.
R.E.S.C.U.E. Remote Control System
Manual C841.N2
Transmitters:
1)
Press
and
release
button
Or
2)
Press
and
hold
button
3)
Red Status LED
Signal is sent to receiver - 1 second pulse
Signal is sent to receiver as long as button
is held. Signal will stop when button is
released.
A) LED On red indicates signal is being
sent
B) LED On bright and solid indicates
battery voltage is ok.
2 Button
1
1 & 2
2
Channel
1
2
3
Function
Motor or Lamp
Motor or Lamp
Motor or Lamp
Power Output
+12v or Ground(-)
+12v or Ground(-)
+12v or Ground (-)
Signal Type
Momentary
Momentary
Momentary
Transmitter
Operation
Receiver Operation
Output
5 Amps Max
5 Amps Max
5 Amps Max
All outputs must be same polarity
Transmitter
Pressed at the
same time
