©
American Audio
®
- www.AmericanAudio.us - Flex 100MP3 Instruction Manual Page 27
FLIP-FLOP™
This feature is a kind of “auto pilot”. When you are using two Flex 100MP3 players and an American Audio®
“Q” Deck™ mixer, you can have one player begin playback when the other ends. You can “Flip-Flop™” single
tracks, the entire disc, or a combination of the two.
To FLIP-FLOP™ single tracks:
1) Connect your system as described in the set up section on page 8.
2) Set your American Audio® “Q” Deck™ mixer's crossfader to the center
position.
3) Set your two Flex 100MP3s to playback in single mode,
Single (52)
should be indicated in the
lcd (28).
4) Load your two Flex 100MP3s with audio discs.
5) After they have both cued, press the
play/pauSe Button (18)
on one play-
er to begin playback.
6) After the first player’s single track has ended the second player’s track will
immediately begin playback.
7) FLIP-FLOP™ will continue until you stop it or power is interrupted.
To Flip-Flop entire CDs:
Be sure your players are both in continuous play mode, make sure
Single mode (52)
does not appear in the
lcds (28)
of both players. Follow all directions for single track FLIP-FLOP™ above. When one player’s disc
ends the other player will immediately begin playback.
Note:
You may combine FLIP-FLOP™ single and continuously playback modes by selecting either single or
continuous playback on your units.
Connecting your Flex 100MP3 to an American Audio® or an American DJ® “Q” Deck™ mixer for “Flip-Flop™”
control: Be sure to connect 1/8” mono mini plugs from the control connection on the rear of your Flex 100MP3
to the 1/8” control jack on the rear of American Audio® “Q” series mixer. That’s it, you’ll be set for FLIP-
FLOP.™
Single black cross line
Single black cross line
mono mini Plug
FLIP-FLOP™
Sample "Q" Start Set-Up. This set-up will allow "Q" start function and Flip-Flop™ function to operate.
Be sure to use 1/8" mono mini plugs only.
Compatible Q-Deck mixer
Figure 37
Figure 36
