41. DRIVE 2 REMOTE JACK -
Connect the
supplied 8 pin din cable from this jack to the
remote control's channel 2 remote connector.
This will allow you to control the player functions
with the remote unit.
42. DRIVE 2 DIGITAL OUT -
This jack sends a
digital stereo out signal. Use this connection to
create near perfect copies of your disc to a Mini
disc, CD-R, or any other recording device with
a digital input.
43. DRIVE 2 AUDIO OUT R & L -
These jacks
send a left and right analog mono output signal.
Use these jacks to send standard audio to a
mixer or receiver. The red colored jack represents
the right channel output and white jack represents
the left channels output.
44. VOLTAGE SELECTOR -
Because power
supplies vary from location to location a voltage
selector switch has been incorporated in the unit's
design. This switch can select a voltage input
of 120v or 220v to accommodate the two major
power source. Always be sure to disconnect the
power plug before changing the voltage.
45. POWER CONNECTOR -
This is the main
power connection. Only use the supplied polar-
ized power cord. Use of any other power may
GENERAL FUNCTIONS AND CONTROLS - PLAYER UNIT
©
American Audio
®
- www.americandj.com - DIGI-PRO™ Instruction Manual Page 13
result in sever damage to the unit. Be sure the
local power matches the unit’s required power.
46. SCRATCH BOX INPUT (Drive 1)-
This jack
is used to receive the digital
Scratch Box
signal.
Use the included stereo mini plugs to connect the
Scratch Box
to the to this jack. Be sure to use
a dual stereo jack for proper functionality. For
more information on the
Scratch Box
refer to the
Scratch Box manual.
47. DRIVE 1 REMOTE JACK -
Connect the
supplied 8 pin din cable from this jack to the
remote control's channel 1 remote connector.
This will allow you to control the player functions
with the remote unit.
48. DRIVE 1 DIGITAL OUT -
This jack sends a
digital stereo out signal. Use this connection to
create near perfect copies of your disc to a Mini
disc, CD-R, or any other recording device with
a digital input.
49. DRIVE 1 AUDIO OUT R & L -
These jacks
send a left and right analog mono output signal.
Use these jacks to send standard audio to a
mixer or receiver. The red colored jack represents
the right channel output and white jack represents
the left channels output.
