4
Cold Water Supply
INSTALLATION SPECIFICATIONS
Drain Stub
The faucet holes (where the supply lines are placed) are located
2
"
in from the edge.
The drain is located
10¾"
inches in from the edge of the bathtub.
Note: Do not use the measurements for the Deck Mount listed above if
you purchased a Wall Mount or Floor Mount.
A
B
Drain Stub
Hot Water Supply
2
"
B
Water Supply Lines
CL
Water Supply
Stub
Deck Mount
CL
10¾"
A
5
SECURING YOUR BATHTUB
Failure to secure your bathtub will void your
warrant
y!
It is very important to secure your bathtub to the
floor. This avoids bending or straining the water
supply connections and drain, if the bathtub is
bumped or moved, possibly causing leaks.
The easiest way to secure your tub is to use a
small amount of glue or epoxy directly on the
floor under each foot. You may do this with the
leveling adjuster attached or without. Please see
drawings below.
Aligning your Bathtub
WARNING
- Failure to
secure your bathtub may
cause leaks if the bathtub
is moved.
ALIGN & SECURE YOUR BATHTUB
Now that the water test is complete, pay careful attention when
transporting your clawfoot bathtub through a narrow doorway. Tilt
your bathtub on its nose, on to a soft surface (
folded towel, sheet,
etc.),
and spin it through the doorway. We recommend doing this
instead of disassembling the feet.
Carefully align your bathtub over the water supply stubs and
drain. For deck mount faucets, it may be helpful
to temporarily attach your faucet and water
supply lines to the bathtub, to aid in aligning
the bathtub directly over the water supply stubs.
A
B
C
Tub Leveler with
Leveling Donut
Washer
Tub Leveler
Floor
Glue
or
Epoxy
Floor
Floor
Glue
or
Epoxy
Tub Leveler
