10
wheel
inside
bracket
outside
bracket
shower door
bolt
diagram 16
B - Handle Installation
1. Set the glass door in a position to enable the assembly of the handle.
2. A left door will have the handle on the left, a right door will have the
handle on the right.
3. Loosen the set screws so you can separate the handles.
4.
5.
6.
Unscrew the long bolt from the handle. Keep all rubber pieces attached to
the screw.
Remove the first set of flat, clear washers from the bolt.
Start with the top hole on the glass door. Place the long bolt through the
hole in the door
(keeping the remaining rubber pieces on the bolt)
. On the
other side of the glass place the flat washers onto the threaded portion of
the bolt.
(dia. 16)
7. Take one side of the handle and screw the long bolt into the end. Just start
the bolt until a few threads catch. Keep loose.
8.
9.
10.
Put the second bolt through the lower hole. Place the flat washer onto the
bolt. Screw the bolt into the bottom handle.
Align the handle on the door and carefully tighten the long bolts. Do not
over tighten.
Place the opposite handle over the long bolts and tighten the set screws to
secure the handle.
diagram 18
Sliding
Door
Fixed
Glass Panel
door slide
bracket
clear
rubber
insert
slide
diagram 17
C - Sliding Glass Door Installation
G12
1.
2.
3.
4.
Locate the shower door wheels
(
Prei
nstalled
:
diagram 17
is for reference only)
To install the wheels on the sliding glass door, unscrew the bolt from the
inside bracket. Place the outside bracket on the outside of the door, and
place the inside bracket and wheel into the cutout section of the shower
door
(diagram 1
7
)
Push the bolt through the inside bracket until it screws into
the outside bracket. Repeat for the remaining wheels.
After 30 minutes to an hour the100% silicone on the fixed glass panel should
be secure enough to finish the door assembly.
(do not use excessive
force on
the door until the silicone is fully dried)
Have the door slide bracket handy and
ready to install. Carefully place the door into position, with the wheels
resting in to the pan threshold channel facing into the shower.
To secure the sliding door to the door slide bracket
(diagram 18)
take the
clear rubber insert of the bracket and place a pea drop of silicone inside
of channel then place on the top end of the fixed glass panel. Next lower
the bracket over the clear rubber insert at the same time making sure the
glass is going into the guide channel, push down leaving a ⅛" gap
between top of the sliding door and the slide.
(pushing the bracket down too
far will create too much friction for the door to slide easily)
To install the two rubber door stops, place a drop of 100% silicone onto the
rubber stops, and position on the left and right wall thresholds, in the center
of where the door will stop.
G11
clear washer
clear
spacer
clear
washer
set screw
shower
inside
screw
G3
shower
outside
5.
HELPFUL HINT: Apply a small bead of silicone between the
rubber insert and the door slide bracket to secure the
bracket from moving over time with use.
