2
This shower system is designed to be installed on a level, bare floor. It is necessary for any existing shower to be
completely removed. Tear out and remove all old material to expose the 2 x 4 wall studs. Clean up the shower area,
removing all dust and old material from the area.
Cold Weather Warning
: We recommend not installing your shower below the temperature of 70°F. The shower will be
fine in cold weather after installation, but during installation bending and handling shower components in cold weather
can cause breakage. Frigid conditions can make some shower components brittle and susceptible to cracking during
rough installation handling.
2
DRY-FITTING THE PAN
TIME
½ to 1 HR
½" cement board
2 x 4 stud
metal flange
pan
diagram 1
floor of pan
silicone bead
It is easier to check alignment of studs and pan without the
drain installed into the pan.
Place the pan in the planned position. Check to see that
the spacing between the metal pan flange and 2 x 4 studs
are flush. Some shimming or sanding of the 2 x 4 studs may
be required to flush the studs with the metal pan flange.
When screwing in the ½" cement board the metal flange
will pull fast to the studs, and will secure the metal pan in
place. (
dia
)
P
PRE-INSTALLATION TEAR DOWN
TIME
8-16 HRS
1
NOTE: Due to some rough handling during shipping, you can
water test pan before installation to check for any issues.
INSIDE
OPTIONAL SHAMPOO SHELF INSTALLATION
TIME REQUIRED
1/2 - 1 HR
4.
On the 2 tiles the Shampoo Shelf will be replacing,
mark 1" from the outside of the grout line, the cut-
out area will be 10" x 22". Cut out the hole for the
Shelf. The smaller the hole the better.
5.
Dry-fit the Shampoo Shelf for alignment of grout
lines.
6.
Using 100% Silicone in-place with a generous
bead around the back of the lip, wipe off excess
silicone with tissue.
1. The Shampoo Shelf was designed to match your
tile size. 12" x 24" tiles, the cut-out hole size is 10 x
22".
2. There is a 1" lip or frame around the Shampoo
Shelf, this will be the water sealed area for the
Shampoo Shelf.
3. The best way to cut the hole is with a small 5"
round diamond blade.
See detailed instructions enclosed with Shampoo Shelf
IMPORTANT: DO NOT USE SHIMS UNDER THE SHOWER
PAN. SHOWER PAN MUST SIT ON A FLAT LEVEL FLOOR.