9a
hinge
pin
side
plate
side
plate
hinge
pin
teflon slide
washer
teflon slide
washer
hinge wall
bracket
screw
(3 places)
1.
2.
3.
4.
5.
6.
7
A H
I
1. Set the glass door in a position to enable the assembly of the handle.
2. Loosen the set screws so you can separate the handles.
3.
4.
5.
6.
7.
8.
9.
diagram 18
clear washer
clear
spacer
clear
washer
set screw
r
i id
r
id
Be careful not to rest the edges of the door on hard surfaces. Tempered glass is
very strong and impact resistant but its weakest point is impact on the edges.
scre
w
DH
DH
HB
Unscrew the long bolt from the handle. Keep all rubber pieces attached to the
screw.
Remove the first set of flat, clear washers from the bolt.
Start with the top hole on the glass door. Place the long bolt through the hole in
the door
(keeping the remaining rubber pieces on the bolt)
. On the other side of the
glass place the flat washers onto the threaded portion of the bolt.
(dia. 18)
Take one side of the handle and screw the long bolt into the end. Just start the
bolt until a few threads catch. Keep loose.
(dia. 18)
Put the second bolt through the lower hole. Place the flat washer onto the bolt.
Screw the bolt into the bottom handle.
(dia. 18)
Align the handle on the door and carefully tighten the long bolts. Do not over
tighten.
Place the opposite handle over the long bolts and tighten the set screws to
secure the handle.
B H
I
Locate the top hinge
GH
and remove the side plate by loosening the two
screws.
(
dia. 19
)
Apply a generous amount of silicone onto the hinge and side plate.
Position the hinge onto the glass door lining up the holes so that the screws are
on the inside of the shower door.
Attach the side plate with silicone applied to the glass and tighten the screws
until the hinge is secure. Wipe off the excess and allow to dry.
Repeat these steps for the bottom hinge.
You will also find a Vinyl Water Shield for the bottom hinge. This can be added
in between the glass door and the side plate to help keep water in the shower
should you have a smaller shower or a shower-head pointed towards the door.
(dia. 19a)
See Images below for illustrated installation examples. You may trim
the Water Shield as needed.
GH
i a r i d
side
plate
HINGED DOOR INSTALLATION
SKIP THIS SECTION FOR NO GLASS OR SLIDING DOOR
TIME
½ to 1 HR
