5
2 x 4 STUDS ALIGNMENT & POSITIONING
TIME REQUIRED
½ to 1 HR
Using the pan and 1B and 2B wall panels, you will be able to check to make sure your 2 x 4 studs are in the needed position and supported adequately.
You will see in
(diagram 2)
extra 2 x 4 studs are added to the door and glass side thresholds for extra strength. You may need to make adjustments for your
faucet or optional shampoo shelf. When you place the bottom sections of the wall 1B or 2B into the shower pan, you can also calculate the needed width and
height of areas to keep free of 2 x 4 studs.
(See installation instructions included with the faucet or shampoo shelf)
6
INSTALLING DRAIN
TIME REQUIRED
½ to 1 HR
#1 trim plate
#2 drain tool
#3 brass pressure ring
#4 rubber seal
#5 drain collar
pan
#6 rubber gasket
#7 teflon slide ring
#8 drain lock nut
apply silicone
around drain collar
sides and under lip
floor hole with
2” drain pipe
diagram 3
1. Remove the shower pan to a safe location to water test.
2. Apply a generous bead of silicone around the shower pan drain hole and around the outside of
the drain collar #5, insert the drain collar #5 into the drain hole.
3. Apply a generous bead of silicone around the drain collar #5 from the underside of the pan.
4. Install the rubber gasket #6 over the drain collar #5, to the underside of the pan, next install the
teflon slide ring #7.
5. Screw on the drain lock nut #8 and hand tighten. Turn drain lock nut #8 approximately 1/4
turn with the wrench to ensure a water-tight fit. Check for a good seal. DO NOT OVERTIGHTEN.
6. Wipe off excess silicone and allow silicone to dry. Follow the manufacturer’s directions for
application and drying time.
SEE SILICONE RECOMMENDATIONS PAGE 7
4
