• Be sure to save the packing carton in the unlikely event the unit
may have to be returned for service
• Do not spill water or other liquids into or on to your fogger. Be
sure that all the fog fluid is kept inside the fluid reservoir
• Be sure that the local power outlet match that or the required
voltage for your fog machine
• Do not remove the top cover under any conditions. There are no
user serviceable parts inside
• Disconnect the unit’s main power when left unused for long peri-
ods of time
• Never connect this unit to a dimmer pack
• Do not attempt to operate this unit, if it becomes damaged in anyway
• Never operate this unit when it’s cover is removed
• To reduce the risk of electrical shock or fire, do not expose this
unit rain or moisture
• Do not attempt to operate this unit if the power cord has been fray-
ed or broken. Do not attempt to remove or break off the ground
prong from the electrical cord. This prong is used to reduce the
risk of electrical shock and fire in case of an internal short
• Disconnect from main power before making any type of connection
• Never block the ventilation holes. Always be sure to mount this
unit in an area that will allow proper ventilation. Allow about 6”
(15cm) between this device and a wall
• This unit is intended for indoor use only, use of this product out-
doors voids all warranties
• Always mount this unit in a safe and stable matter
• Please route your power cord out of the way of foot traffic. Power
cords should be routed so they are not likely to be walked on,
pinched by items placed upon or against them
• The unit should only be serviced by qualified service personnel
when:
A. The power-supply cord or the plug has been damaged.
B. Objects have fallen, or liquid has been spilled into the unit.
C. The unit has been exposed to rain or water.
D. The appliance does not appear to operate normally or
exhibits a marked change in performance.
DynoFog II™
Safety Precautions
DynoFog II™
Description
©
American DJ Supply
®
- DynoFog II™ Instruction Manual Page 3
The new DynoFog II™ includes a revolutionary new heating ele-
ment that has been specially designed to prevent excessive particle
build up that can cause premature fogger failure. This fog machine
includes a wide-angle spray nozzle and long-life pump that was spe-
cially designed for high performance fogger output. The fog machine
also includes a 10 foot (three meters) remote control, that may be
removed during periods on non-use. When the remote is not con-
nected the fog machine may be manually operated by function switch
located on the top of the unit.
©
American DJ Supply
®
- DynoFog II™ Instruction Manual Page 4
DynoFog II™
Set-Up
1. Open the shipping carton and carefully remove the unit from the
shipping carton.
2. Be sure to remove all the packing material especially around the
nozzle.
3. Set the fog machine on a flat dry surface and remove the reservoir
cap located on the top of the machine.
4. Remove the supplied bottle of American DJ
®
branded fog juice
from the carton. Fill the fog machine reservoir with the fog juice
and replace the cap.
5. Remove the remote control from the carton. Firmly attach the
remote control to the remote control socket located on the rear
unit.
6. Plug the unit in to a matching power supply. Wait approximately
five minutes for the fogger to reach normal operating temperature.
7. Follow the operating instructions on the next page for proper
operation.
DynoFog II™
Features
• 1000 Watt Heater Core
• Removable Remote Control Operation
• Light Weight & Portable
• 1 Quart Removable Tank
• Includes hanging Bracket
• Output Button on Unit
