fog array™
Operating Instructions
Power Supply:
Before plugging your unit in, be sure the source
voltage in your area matches the required voltage for your American
DJ
®
Fog Array™ before attempting operation.
Operation:
Never connect the remote control to the unit when
the unit is powered on!
After the fog machine has been plugged into
a wall socket with a matching power supply, flip the power switch to
the on (up) position. When the unit is powered on the red LED on the
top of the unit, and the green LED on the remote (if connected) will
immediately begin to glow. The unit will automatically begin to warm
up to normal operating temperature. Warm up time may vary but the
unit will take approximately five minutes to warm to normal operating
temperature, the temperature the unit needs to turn the fog juice in to
mist. If you will be using the remote, be sure the remote control has
been connected as described in the set-up section of this manual on
the previous page. Never connect the remote control to the unit when
the unit is powered on. After the unit has warmed up to normal oper-
ating temperature, the green LED on the remote (if connected) and
the red LED on top of the unit will turn off indicating the unit is ready
to emit fog. To emit fog, simply press the red button on the remote or
the red button on the top of the unit. For best results, never hold the
output button down for longer than 30 seconds. If the red LEDs are
off and fog does not come out after holding the button down for 30
seconds, please contact customer support for further instructions.
Fog Juice:
Always be sure there is an adequate supply of American
DJ
®
branded fog juice™ in the fluid reservoir. Running the fog
machine dry will cause pump failure and or clogging, a condition that
is not covered under the manufactures warranty. This is the largest
cause of failure in fog machines. Only American DJ
®
branded Fog
Juice™ is recommended, not all fog juice is made the same and not
all fog juice is compatible with this fog machine. Using American DJ
®
branded fog juice™ will ensure proper operation, using a third party
fog juice may clog the unit and will void the manufactures warranty.
Caution:
Before removing or replacing the remote control unit be
sure main power has been turned off.
©
American DJ Supply
®
- Fog Array™ Instruction Manual Page 5
©
American DJ Supply
®
- Fog Array™ Instruction Manual Page 6
fog array™
trouble Shooting
The Fog Array™ carries a one year (365 days) limited warranty.
Please fill out the enclosed warranty card to validate your purchase.
All returned service items whether under warranty or not, must be
freight pre-paid and accompany a return authorization (R.A.) num-
ber. The R.A. number must be clearly written on the outside of the
return package. A brief description of the problem as well as the R.A.
number must also be written down on a piece of paper included in
the shipping carton. If the unit is under warranty, you must provide a
copy of your proof of purchase invoice. You may obtain a R.A. num-
ber by contacting our customer support team on our toll free custom-
er support number. All packages returned to the service department
not displaying a R.A. number on the outside of the package will be
returned to the shipper.
fog array™
Warranty Registration
If you experience low fog output, pump noise, or no fog output at all,
disconnect and discontinue use immediately. Do not attempt to con-
tinue pushing the remote control’s activation button as this may dam-
age the fog machine. Check fluid level, the external fuse or breaker,
remote connection, and be sure the wall outlet is sending power. If
all of the above appear to be okay, and the unit fails to operate cor-
rectly, the unit will require service. Return the machine to an American
DJ
®
authorized dealer or service center.
