background image

•  Be sure to save the packing carton in the unlikely event the unit 
  may have to be returned for service
•  Do not spill water or other liquids into or on to your fogger. Be
  sure that all the fog fluid is kept inside the fluid reservoir
•  Be sure that the local power outlet match that or the required 
  voltage for your fog machine
•   Do not remove the top cover under any conditions. There are no
  user serviceable parts inside
•   Disconnect the unit’s main power when left unused for long peri- 
  ods of time
•  Never connect this unit to a dimmer pack
•   Do not attempt to operate this unit, if it becomes damaged in anyway
•  Never operate this unit when it’s cover is removed
•  To reduce the risk of electrical shock or fire, do not expose this 
  unit rain or moisture
•  Do not attempt to operate this unit if the power cord has been fray-
  ed or broken. Do not attempt to remove or break off the ground
  prong from the electrical cord. This prong is used to reduce the  
  risk of electrical shock and fire in case of an internal short
•  Disconnect from main power before making any type of connection
•  Never block the ventilation holes. Always be sure to mount this 
  unit in an area that will allow proper ventilation. Allow about 6” 
  (15cm) between this device and a wall
•  This unit is intended for indoor use only, use of this product out- 
  doors voids all warranties
•  Always mount this unit in a safe and stable matter
•  Please route your power cord out of the way of foot traffic. Power 
  cords should be routed so they are not likely to be walked on, 
  pinched by items placed upon or against them
•  The unit should only be serviced by qualified service personnel 
  when:
   

A. The power-supply cord or the plug has been damaged.

   

B. Objects have fallen, or liquid has been spilled into the unit.

   

C. The unit has been exposed to rain or water.

   

D. The appliance does not appear to operate normally or    

      

    exhibits a marked change in performance.

  Haze Generator™  

 

       Safety Precautions

©

American DJ Supply

®

  -  www.americandj.com  - HAZE generator™ User Manual Page 3

  HAZE Generator™    

  Operating Instructions

Always be sure to maintain an adequate supply of American DJ

®

 Brand 

Haze  Juice™  in  the  fluid  reservoir.  Running  the  haze  machine  dry  will 
cause pump failure and or clogging. This is the largest cause of failure in 
fog and haze machines. 

Stand Alone Operation:

 This unit may be operated with or without the 

remote control attached to the unit. If the remote is not connect the unit 
will immediately begin to function and emit haze as soon as the unit is 
turned on. 

Remote Operation:

  The  remote  allows  the  unit  to  run  automatically  or 

by  timer.  The  remote  has  a  “on/off”  button,  that  must  be  turned  on  to 
operate the unit. A red LED above the on/off button will glow when the 
remote is activated.

Manual: 

The remote has a green button, this button allows operation to 

be controlled manually. Haze will emit as long as this button is activated, 
a  green  LED  above  this  button  will  glow  when  the  manual  function  is 
activated. 

Timer: 

The timer function allows haze to be emitted at designated inter-

vals. To activate the timer function press the yellow timer button. A yel-
low  LED  will  glow  when  the  timer  function  is  activated.  The  “duration” 
button  will  control  the  length  of  haze  burst.  The  “interval”    button  will 
control the time between burst. Turing these knobs in a clockwise direc-

  Haze Generator™  

 

 

 

 

Set-Up

1. Open the shipping carton and carefully remove the unit from the  
  shipping carton.
2. Be sure to remove all the packing material especially around the  
  nozzle.
3. Set the machine on a flat dry surface and remove the reservoir  
  cap located on the top of the machine. 
4. Fill the haze generator reservoir with American DJ branded haze  
  fluid only and replace the cap.
5. Remove the remote control from the carton. Firmly attach the    
  remote control to the remote control socket located on the rear  
  unit.
6. Plug the unit in to a matching power supply and flip the power  
  switch to the on position. 
7. Follow the operating instructions on the next page for proper    
  operation.

©

American DJ Supply

®

  -  www.americandj.com  - HAZE generator™ User Manual Page 4

Reviews: