American DJ Quad Phase Go User Instructions Download

Page: 8 / 12

Quad Phase Go

Operation

together via the XLR connector on the rear of the units. Remem-

ber the Male XLR connector is the input and the Female XLR

connector is the output. The first unit in the chain (master) will use

the female XLR connector only - The last unit in the chain will use

the male XLR connector only. For longer cable runs we suggest a

terminator at the last fixture.
2. On the Master unit press the MENU button until “SLND” is dis-

played, and press ENTER. Press the UP and DOWN buttons until

“MAST” is displayed, and press ENTER. You have now assigned

the unit as a Master in the Master-Slave configuration.
3. For the slave units press the MENU button until “SLND” is dis-

played, then press the UP and DOWN buttons until either “SL 1”

“SL 2” is displayed, and press ENTER.

NOTE: In a Master/Slave configuration you can set one fixture

to Master and then set the next fixture to “SL 2”, the fixtures

will now have contrast movement to each other.

4. The slave units will now follow the Master unit.
5. The optional UC3 Controller (not included) may be used to con-

trol different functions including blackout.

Quad Phase Go UC3 Control

With this feature you can connect the fixtures to one another

using the IEC input and output sockets. The quantity that can be

connected is 6 fixtures maximum. After 6 fixtures you will need

to use a new power outlet. They must be the same fixtures. DO

NOT mix fixtures.

Quad Phase Go Power Cord Daisy Chain

Universal DMX Control:

This function allows you to use a Elation

universal DMX-512 controller to control the chases and patterns,

dimmer and strobe. A DMX controller allows you to create unique

programs tailored to your individual needs.

1. The Quad Phase Go is a four channel DMX fixture. See page 17

for detailed description of the DMX values and traits.
2. To control your fixture in DMX mode, follow the set-up procedures

on pages 7-9 as well as the set-up specifications that are inclu-

  ded with your DMX controller.
3.  Use the controller’s faders to control the various DMX fixture traits.
4.  This will allow you to create your own programs.
5.  Follow the instructions on page 11 to set the DMX address.
6.  For longer cable runs (more than a 100 feet) use a terminator on

the last fixture.
7. For help operating in DMX mode consult the manual included

with your DMX controller.

Sound Active Mode:

This mode allows a single unit or several units

linked together, to run to the beat of the music.

1. Tap the MENU button until “SOUN” is displayed, and press ENTER.
2. Press the UP or DOWN button so that “ON” is displayed. The unit

will now run to the beat of the music.
3. The sound sensitivity can be adjusted by pressing the MENU

button until “SENS” is displayed, and then press ENTER. Use the

UP or DOWN buttons to adjust the sound sensitivity, 1 being the

least sensitive, and 100 being the most sensitive.
4. The optional UC3 Controller (not included) may be used to con-

trol different functions including blackout.

Master-Slave Operation: