OPERATION
Power Sources
DO NOT CONNECT THE EQUIPMENT TO A POWER
SOURCE UNTIL READY TO "POWER UP''. Make all
connections to the 2083/06 code input and relay connections
and set the DIP switches prior to power up.
The 2083/06 Code Translator does not contain an On/Off
Switch. The socket outlet shall be located near the equipment
and shall be readily accessible. The 120 V units are supplied
with a pendant 3-wire cord and plug for mating to the primary
source outlet. The 230 V units are supplied with a Euro style
IEC 320 type inlet. A suitable detachable cord should be
connected between the IEC 320 inlet and the power source.
The cord should conform to all national and local use code
requirements. A green POWER LED indicator located on the
rear panel illuminates when power is applied.
Code Translators are available in two models, depending on
the power source to be used:
AD2083/06
120VAC, 50/60 Hz
ADS2083/06X
230VAC, 50/60 Hz
The 2083/06 unit has fuse power protection. The fuse sizes for
replacement are;
120 V - 250 V, SB, 125 mA, 5 x 20 mm
230 V - 250 V, T, 125 mA, 5 x 20 mm
Operating Indicators
When the unit is receiving valid code, the green CODE LED,
on the rear panel, is illuminated. The LED stays lit for 5
seconds after code is removed. If this LED does not light, a
problem in the unit or its interconnection may be indicated.
If an alarm input is activated, the green ALARM LED
illuminates, and the alarm relay closes. The ALARM LED
will go out and the alarm relay will open ten seconds after the
alarm input is reset or removed.
Controlling Pelco Receiver Features
The 2083/06 supports the transmitted codes for Pelco Intercept
Domes features. This includes the standard American
Dynamics keyboard functions for camera Pan, Tilt, and Lens
control. For those Pelco domes which implement preset
capability, the 2082/06 supports AD keyboard commands for
32 presets per receiver.
Pelco domes support the use of eight auxiliary actions. The
first three Pelco dome auxiliary channels are controlled via the
normal AD keyboard AUX commands. Pelco dome auxiliary
channels 4 through 8 are controlled from the AD keyboard
using the commands indicated in Table 4, page 5.
In addition, the 2083/06 provides AD keyboard commands for
the control of several unique Pelco Intercept Domes functions.
These additional functions and the associated AD keyboard
commands are shown in Table 4, page 5.
6
OPERATION
IF YOU ENCOUNTER ANY PROBLEMS
OPERATING THIS UNIT, OR NEED ASSISTANCE,
CALL OUR TECHNICAL SUPPORT CENTER:
within the United States: 1-800-442-2225
outside the United States: (914) 624-7640
