27
INTRODUCTION
ENGLISH
PREPARATION
RECORDING
OPERATION
PLAYBACK
OPERATION
NOTICE
■
When there is an alarm input in the STOP mode, a slight delay will occur in start of the alarm recording.
■
When the pause mode continues for 10 minutes the VTR goes to the stop mode. This occurs in order to protect the video heads
and tape. While in pause mode, the video head is constantly tracing the same location.
■
Alarm recording will not operate from power off mode and timer power off mode.
Event Recording
If event recording is desired, set the VTR’s recording mode to L01, L02 or L03. In order to accomplish this press the time mode
button until “L01”, “L02” or “L03” is shown.
If there is no alarm input present when in “L01”, “L02” or “L03” mode, the VTR automatically forwards 2 fields with recording every
appointed time (L01: 1min, L02: 2min, L03: 3min.) to protect the tape and the video head from damage.
Warning at Alarm Recording
When an alarm signal is input, the buzzer sounds and the alarm display on the VTR DISPLAY lights.
If an alarm condition arises, the alarm function operates with an alarm input signal.
Operation at Alarm Input
When there is an alarm during recording, recording pause or stop modes, the VTR automatically goes into alarm recording mode.
The VTR can be programmed to record in the following time modes during alarm recording: A3, A12, A18, A24.
ALARM RECORDING
Recording
Recording pause
Stop
Recording
Recording pause
Stop
Alarm input
Alarm Recording
1ST 1/ 4/96MON 21:07:13
AL6 1/ 4/96MON 21:07:13
AL5 20/6/96THU 23:14:10
AL4 12/7/96FRI 19:14:12
AL3 25/7/96THU 0:14:12
AL7 --/--/----- --:--:--
ALARM RECALL
AL1 19/8/96MON 20:35:09
MENU=[DISPLAY]
AL2 7/ 8/96WED 21:35:16
M E N U
CLOCK ADJUST
SETUP
SETUP
DISPLAY MODE
END=[DISPLAY]
PROGRAM
ALARM RECALL
TIME DATE SEARCH
• At 1ST, the first (oldest) alarm input information is displayed.
• At AL1, the latest alarm input information is displayed.
• When more than seven items are input, the old information is erased and the new information is stored in the memory.
• To erase the alarm recall contents, press the ALARM button to change the counter display to alarm counter and press the
RESET button.
A3, A12, A18,
A24 hours
Alarm display lights and then blinks when alarm recording is finished.
REC
ALARM
H
SP
• Turn off the BUZZER switch to stop the buzzer.
• To stop the alarm display blinking, press the ALARM button to change the counter display to the alarm counter and then press
the RESET button.
Alarm Recall Display
Check the alarm input information on the ALARM RECALL screen.
17:30:13 A 3
28/8/96 A01
Changes to a display of A3, A12, A18 or A24.
Changes to a display of A3,
A12, A18 or A24.
The day of the week display
changes to the alarm number
during alarm recording.
