7
When you receive your
Magnum 7500 Corn/Pellet Furnace,
be careful to inspect all parts and
components to make sure that nothing was damaged or lost in shipment. If there was shipping damage,
be sure to report it to your Magnum 7500 reseller, and the shipping company that delivered your unit.
Freight damage claims must be made to the Freight Company immediately.
If parts are missing
contact your local
Magnum 7500
reseller or contact the factory right away.
Your satisfaction is our top
priority
.
If damage is not reported to the freight company before signing for it, you will not receive re-
imbursement for freight damage.
To uncrate your
Magnum Corn/Pellet Furnace:
1)
Cut the banding straps and open the carton lid. The carton is stapled to the wood pallet so it will be
necessary to pull the cardboard loose from the pallet. Remove the crating box carefully lifting up over
the top of the unit. Be careful not to scratch the unit with the staples. Remove the wood blocks and
plastic. We strongly urge you to recycle the packaging materials to help protect the environment.
IMPORTANT:
Proper installation of this furnace is crucial for proper and safe operation. Installing this
product improperly may result in a house fire and personal injury. All applicable building codes for your
location must be followed. In areas where building codes require additional steps to the installation of
this product not included in this manual, the building codes will take precedent and must be followed.
Contact your local building inspector to obtain any necessary permits or inspection guidelines before
installing the product.
(This appliance must be installed and serviced by a trained licensed heating
contractor to assure proper installation and warranty of this product) Warranty Labor, parts,
shipping or any other costs will not be covered if a trained installer does not install the unit.
Consult your local heating contractor for proper heating requirements, placement of your Magnum
7500 Corn/Wood Pellet Furnace and duct sizing.
OUTSIDE AIR HOOKUP TO THE FURNACE IS REQUIRED (3” diameter)
This furnace has to be exhausted with 3” or 4” class L vent. Furnace cannot be vented with another
appliance.
9
DISCONNECT THE POWER CORD BEFORE SERVICING THIS FURNACE. A power
surge
protector is required.
The unit must be plugged in to a
grounded
110 -volt power source.
9
Always route the power cord away from the unit. Do not route cord in foot traffic areas. Do not
pinch cord under furniture. Do not add any additional length to the power cord.
9
This product requires simple periodic maintenance for proper operation and long life of the furnace.
Read and follow the maintenance schedule closely.
9
The Magnum 7500 furnace is designed, approved and tested to burn shelled corn, or wood
pellets.
The burning of other solid fuels such as cord wood in this furnace is not permitted. If you are
SAFETY STEPS
UNPACKING YOUR MAGNUM 7500 CORN/PELLET FURNACE
