Rev 10/29/13
10
Close Slow Down
– Move the door to the desired close slow position
then look at the value of the encoder. Enter that value into the set
point field. Press the “Ent” button, then key in the desired set point
then press the “Ent again..
Safety Edge Slow Down
– This is a smart controller, so when a safety
edge is triggered it logs the position at which it occurred. On the next
close cycle it will slow down at the value the collision occurred plus and
minus this set point value. (example: If you enter a value of 300 in this
field and the collision occurred at 3000, the door would move at its
normal speed closed until it reaches 3300 and continue to move slow
until it reaches 2700n then speed up to full speed.)
Auto Close Timer
– Here is where the value that the controller waits
after the door is open before it closes automatically is entered.
Please
note that the Auto Close Timer is only active when selected to Auto.
Auto Close Timer Program
– There are three sub-programs for the Auto
Close timer. This can be setup for program 0, 1 or 2 and their functions
are below:
Program 0 = This disables the auto close timer.
Program 1 = The auto close timer will commence timing when the door
reaches the fully open limit and “Auto” is selected.
Program 2 = The auto close timer will only commence timing when the door reaches the fully
open limit and “Auto” is selected, input 6 is triggered and cleared and the safeties are not
being triggered.
Pushbutton Program
– There are two program selections that can
be made, see below.
Program 0 = When selected this ignores inputs 1, 2 and 3 (Open,
Close and Stop.
)
Program 1 =Inputs 1 and 2 are active and service as open and close signals respectively.
M
*
CK
