7
4)
Install the Power wires to Case.
5)
Insert the two number 8AWG electrical cables through the Units
Electrical cable access hole. (Hint: Strip the cables before clamping
them down. This will make it easier in the next step).
6) Lift the water heater and slide the tab of the mounting bracket on the back
of the
water heater (A)
over and into the opening on the
wall mounting
bracket (B)
as shown in Figure 3. Lock them by the screws ST3.5X12
provided.
Loosen the 3 screws and remove the
metal plate from the back of the
unit. Install the correct wire clamp
for the service wire being used.
Insert the power wire go throught
the hole in back of the unit and
reattach the metal plate to the back
panel with the 3 screws.
Install Clamp
onto the metal
plate as shown.
Prepair wires and
insert wires through
then tighten clamp
as shown.
